User manual

Adit 600 - Release 10.1.1 5

Quick Start

Assembly of Adit 600

NOTE: E1 is not supported in this release of the Adit 600 Controller. It will be

supported in a future release.

The cards should be positioned in the Adit 600 chassis as follows:

Note: Slots are labeled on the top and the bottom of the chassis.

 Power Supply in the POWER Slot

 E1 or T1 Controller in Slot A

 Service Cards can be in any slot 1 through 6.

Note: When an Adit 600 is mounted to the wall, cards that use the front cable

connections should be loaded from Slot 6 to 1. This will minimize card access

issues due to cable interference.

 Always install blank faceplates in any unused slots.

Service Card Slots

123456

APOWER