User manual

Adit 600 - Release 10.1.1 7

Quick Start

Compliant Installation

1. Connect all of the signal cables as shown in the illustration above, and secure

them with a plastic tie. Dress the signal cables toward the left of the Adit 600.

2. If using the 115V Power Supply, connect the -48 VDC battery power cable.

3. Secure the ground lugs to the terminals using the nuts provided.

4. Secure the power cable and the ground cable with a plastic tie (not included).

Keep these cables separate from the signal cables.

5. Terminate each signal cable to its appropriate connector.

6. Secure signal cables using the holes along the bottom of the rack and plastic

ties (not included).

WARNING! ADDITIONAL PRIMARY PROTECTION IS REQUIRED WHEN CONNECTING

T1/E1

OR FXS INTERFACES TO EXPOSED OFF-PREMISE COMMUNICATION

CONDUCTORS. SECONDARY OVERVOLTAGE AND OVERCURRENT PROTECTION IS

PROVIDED ON THESE INTERFACES FOR LIGHTNING SURGE, AC POWER CONTACT

AND INDUCTION. IT WILL BE THE RESPONSIBILITY OF THE INSTALLER TO UTILIZE

LISTED PRIMARY PROTECTORS AND FOLLOW INSTALLATION REQUIREMENTS PER

LOCAL OR NATIONAL REGULATIONS.

Power Cord

-48 VDC

Battery Power

Alarm Wiring

Signal Cables

Power Cables

Grounding Cable

Ferrite Bead

with cable loop

RS-232 craft port

25-pair telco connector

10Base-T Ethernet

T1/E1 connectors

Ferrite Beads

areinred