User's Manual

EdgeFLEX 600 - Release 2.0 2-3

EdgeFLEX 600 Installation

Chassis Components

Fan Tray, System Interfaces, and Power Supply Units

The following components are standard features of the EdgeFLEX 600 chassis:

 System interfaces (Ethernet, RS-232, etc.)

 Air filter

 Fan tray assembly (located in the front right of chassis)

 Cable management flange at the left front

 Bezel at the right front of the chassis

 DC power input connectors (located on the modular Power Supply Unit at the top of the chassis)

Front Panel LEDs and System Interfaces Locations

The following illustration shows the location of the alarm/status LEDs on the Management card, and

the system management interfaces, timing interfaces, and alarm relay contacts.

Power Supply Unit LED Locations

The following illustration shows the location of the alarm/status LEDs on the EdgeFLEX 600 DC

Power Supply Units. The PSU OK LED indicates the status of the PSU; green indicates that the PSU is

functioning properly, red indicates that the PSU is experiencing a fault or (in the case of a redundant

PSU with the system powered by the other PSU) that DC power has not been connected to the PSU.

Management Ethernet Ports 1 & 2

Alarm Relay Contact Blocks

OMT Receptacles 1 & 2

Alarm Cutoff Button

Lamp Test Button

System Alarm LEDs

RS-232 Serial Management Ports 1 & 2

Timing Inputs and Outputs