User's Manual

EdgeFLEX 600 - Release 2.0 2-5
EdgeFLEX 600 Installation
Installing the EdgeFLEX 600 Chassis in a Rack
2. Insert each of the four 6-32 1/4-inch flathead screws through the flange holes and into the
chassis.
3. Use a #2 screwdriver to tighten the screws.
4. Position the left-hand mounting flange so that the holes in the flange align with the
corresponding holes in the chassis, and that the flange face is in front, as shown in step 2.
5. Insert each of the four 6-32 1/4-inch flathead screws through the flange holes and into the
chassis.