Adapter KTA Series User Manual
1. Introduction ........................................................................................................................................................... 3 2. Sketch .................................................................................................................................................................... 3 2.1 Ports figure ...............................................................................................................................................
1. Introduction KTA series is one of VoIP terminal products, with one port connecting with regular PSTN terminal devices and one port connecting with Internet. It transfers voice through net. By the management of soft-switch platform and the support of telecom, KTA can communicate with VoIP terminals and dial to regular phone inexpensively.
2.2 LED Indicators Power TX RX Service Phone MSG Power——Power On LED TX——Network data being transmitted RX——Network data being received Service——Service connected (Remains illuminated when successfully logged-on to server) Phone——phone in operation (phone in-used when light on means working under VoIP, when light off means working under PSTN) MSG——unanswered call LED (unanswered call appeared if light on) 2.
(3) Plug one side of the RJ-11 of phone line to the PHONE Port(FXS) ⑤of KTA, plug another side of the phone line into user terminal (phone, line entrance to PABX, etc.). (4) If you are the KTA1010,KTA1011’s user, put the phone line to the LINE Port(FXO) ⑥of KTA, you will have the both function of VoIP and PSTN. (5) Plug the accessory power-adapter into the power outlet, then connect the output-plug to power-port ① of the KTA.
After network connection, please pick up handset, press key “#*047#” to hear IP address of the adaptor box. In the address field of browser, type the IP address and press ENTER to display the Settings page. A log-in page will be shown. Enter log-in password to set parameters. The default password is 1234. If adaptor box cannot get IP, enter “##3427# to cancel DHCP mode. After reset and beep sound heard, please pick up the handset, enter “#73847#xxx*xxx*xxx*xxx#” to set IP address of adaptor box.
Fill in DNS Fill in DNS2 DHCP: If your router (or other network device) is configured to allocate an IP address to the KTA automatically then you can simply set the KTA up for DHCP operation and no other network parameters need to be completed. PPPoE: If your ADSL modem (or other network device) does not allow you to configure PPPoE then you may need to configure this in the KTA.
Instruction: Depending on your service provider the KTA may display “gk zone” instead of “service address”. Notice: If login failed, contact your service carrier to adjust parameters. Do not ajust default value in most cases. ¾ Audio Settings Audio codec Ringtype Voice active detection auto gain control auto echo cancellatio Notice: All above audio parameters are default settings. Contact your operator to adjust the corresponding parameters if any problems.
¾ Upgrade Click “Update Firmware” of the right-bottom of setting page. KTA would automatically reboot after uprading, then please press keys on the phone as #358#（#DLT#）to restore default settings and reboot again! Note: If you have been instructed to use the “Upgrade Tool” to perform the upgrade then you will need to enable “Remote Access Permission”. This is done from your telephone handset by dialing #767#.
Every KTA can call any land or mobile phone anywhere in the world. Please dial with the service carrier’s dialing rule. Press “#” after you dial the phone number. Example 1: If a U.S service carrier’s dialing rule: To call a U.S or Canada number, please first dial 1, then the telephone number. KTA user calling an U.S/Canada regular number 213-666-8888. Pick up the handset, when you hear the dial tone key in 12136668888 followed by #. Example 2: If a U.
Please input the forwarding number Please type in the target number, which will be forwarded to. Notice: Call forwarding target number must be a PSTN number, with more than 7 digits. Example 1: If a U.S service carrier’s dialing rule: To forward to a U.S or Canada number, please first dial 1, then the telephone number. KTA user wants to make a call forward to 213-666-8888, please fill in 12136668888. Example 2: If a U.
z Humidity: 10% to 90% no dew 5.3 Dimensions z 166.4x 119x 31.6mm (L x W x H) 6.
z z z z z z z z z Voice active detection Comfortable noise generation Echo cancellation Dynamic buffer management—minimize effect to voice quality caused by audio delay jitter Supports NAT Supports.H.323/SIP Supports Remote Upgrade Supports Call Forwarding Lightningproof 7.2 Standards and agreements z z z z z z z z z z z z z z IEEE 802.3 10 Base-T G.711A, G.711µ, G.723.1 5.3K/6.3 Kbps and G.729 audio codec H.
impact, and do not leave the product in dump or highly humid conditions! Current user manual is made based on the functions of present products, if any content change has made, no further notice.
