Owner Manual

www.CasablancaFanCo.com
1.888.227.2178
14
M8515-01 • 11/15/18 • © 2018 Casablanca Fan Company
3
Installing the Wall Plate Bracket
Snap the Wall Control into
the Wall Plate Bracket.
4
Wiring the Wall Control
1. Connect the grounding wire
from the wall control to the
ground control from the
switch box using the provided
wire nuts.
2. Connect the “LIVE IN” from
the switch box to the “~VAC”
from the wall control using the
provided wire nuts.
3. Connect the “LIVE OUT” from
the switch box to the “FAN”
out from the wall control using
the provided wire nuts.
4. Push all wires into the switch
box.
Wall Control For Single Switch
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Ensure the power is OFF at the outlet
box and wall switch location before
proceeding with installation.
Turn Power
OFF
1
Turning off the power
2
Installing the battery
To access the battery compartment,
slide the battery door up.
Replace the used battery with two
AAA batteries when needed.
Battery
Door
If you have a dual switch setup, go to page
18 for dual switch installation instructions.