Owner`s manual

10
POWER

off during cleaning or servicing the fan and during thunderstorms. It is also used
to exit or enter additional programs.
must be left on to retain a previously set fan speed or light level.
R
SPEED CONTROL

audible tone of increasing pitch.
To select the desired fan speed:

rotating at the slowest speed, and will increase in steps.
2. Release the button when the desired speed is reached.

each time the FAN
button is used. To maintain this level of speed, turn the fan
on by pressing FAN less than one second. To lower speed, turn fan off, then on by
pressing and holding the FAN 
the fan is on, you may increase the speed by pressing and holding the FAN button
until the desired speed is reached, then release it.
R
R

to upward or from upward to downward.
To reverse the airflow:
1. Make sure the FAN is on.
2. Press the REVERSE button.
REVERSING AIRFLOW
Note: A four-toned signal indicates the command was
accepted by the fan. A few seconds later the fan will slow
to a stop and then reverse direction.
R
To turn the lights off and on, press and release the LIGHT button for less than
one second.
To vary the light brightness:

come on at their lowest level and gradually become brighter.
2. Release the LIGHT button when the desired brightness level is reached.

the same brightness the next time the LIGHT
button is used. To maintain this
level of brightness, press the LIGHT button for less than one second. To lower
the brightness, turn the lights off, then press and hold the LIGHT button until

brightness level by pressing and holding the LIGHT button until the desired level
is reached, then release it.
LIGHT
FAN CONTROL
ON - OFF
A momentary press
of the FAN button
TO CHANGE SPEED
Press and hold FAN
button longer than
one second
LIGHT CONTROL
ON - OFF
A momentary press of
the LIGHT button
TO CHANGE
BRIGHTNESS
Press and hold LIGHT
button longer than one
second
R
Programmed into every Inteli-Touch Series fan is an Automatic
Demonstration Program. It can be used to fully demonstrate and
test the operation of the fan.
To enter the demonstration program:

fan memory ready for programming.

3. Immediately operate the buttons in the following sequence:
A multi-tone signal will verify the start of the test program which
proceeds as follows:
 
 
 
 
 
 
 
 
 


cancelling the program.
AUTOMATIC DEMONSTRATION PROGRAM
FAN + LIGHT + FAN + LIGHT + FAN
In t e l I •to u c h
®