Owner`s manual
12
W-62 BRACKET / HOLSTER REMOVAL
CONTROL BRACKET INSTALLATION
Standard Light Switch
Step A. Remove the two screws holding the switch cover
plate. Do not remove the cover plate.
Step B. Orient the control bracket as shown and line up the
two inner mounting holes with those on the switch.
Step C. Insert and tighten the screws using the provided
screwdriver.
Inner
mounting
holes
Control
Bracket
Standard
Toggle
Switch
Switch
Cover
Plate
Rocker Light Switch
Step A. Break off the two tabs by pushing outward.
Step B. Remove the two screws holding the switch cover
plate. Do not remove the cover plate.
Step C. Orient the control bracket as shown and line up
the two inner mounting holes with those on the switch.
Step D. Insert and tighten the screws using the provided
screwdriver.
Outer
mounting
holes
Control
Bracket
Rocker
Light
Switch
Switch
Cover
Plate
Step A. Locate a 2x4
wall stud in a convenient
location.
Step B. Orient the control
bracket as shown over the
2x4 stud.
Step C. Insert the 1" wood
screws in either the inner or
outer mounting holes and
tighten using the provided
screwdriver.
Decor Ovalhead Screw
6-32 X 1"
Anchor
Panhead
Screw
Drywall Anchor
used in situations where mounting to a stud is not possible.
Use the inner mounting holes. After securing the anchor,
discard the anchor’s pointed screws and use the 6-32 decor
ovalhead screws supplied.
SAFETY FIRST: To reduce the risk of electrical shock, this fan must be installed with an isolating wall control/switch.
Wood
Screw 1"
Step 1. Remove the two 6-32 x
5/16” screws holding the bracket to
the holster. Save screws for later.
Holster
Bracket
ATTACH HOLSTER TO BRACKET
Step 2
to the bracket.
only the control provided with this fan.
Ad v A n •to u c h
®