Owner`s manual
7
Ba r o l o
®
HANGING THE FAN
Step 5a. To hang the fan body in the canopy, hold the fan
body firmly and insert the ball into the canopy opening.
Check that no wires are pinched. Rotate the fan body until
the slot in the ball fits into the pin opposite the canopy
opening.
Step 5b. Trim excess motor wires, leaving at least 6 inches
above the downrod. Strip
1
/
2
-inch insulation from the end
of each wire using a wire stripper (available at your local
turned upward and pushed carefully into the outlet box.
Step 6. Attach the fan wires to the ceiling fixture outlet box
wiring by placing the bare ends of the wires side by side and
then securing with a wire nut. Test that the connection is
secure by pulling on the wire nut. Connect in this order:
assembly of fan to GROUND conductor of power
source. Secure with wire nut.
ceiling fixture outlet box. Secure with wire nut.
wire
in ceiling outlet box. Secure with wire nut.
After making the wire connections, the wires should
be spread apart with the grounded conductor and the
equipment-grounding conductor on one side of the outlet
box and the ungrounded conductor on the other side of
the outlet box.
NOTE: If the color of your ceiling wires differs from that
described, consult an electrician.
Step 7a. Tuck the wires into the canopy with the wire nuts
are on opposite sides of the canopy and all wires are clear
of the canopy opening.
Step 7b. Install the canopy hatch with the last canopy screw
and lock washer using the provided screwdriver. To do this,
tilt the fan body away from the hatch opening. Tighten
the screws firmly.
Step 7c. Straighten the fan, then check to ensure there is
no movement between the canopy and the ceiling or the
downrod and the ball assembly.
CANOPY HATCH INSTALLATION
Ball
Slot
Pin
2 BLACK wires
2 WHITE wires
3 GREEN wires
Wire nut
CANOPY ELECTRICAL CONNECTIONS