Owner`s manual

8
Step 9. Attach the fan wires to the ceiling fixture outlet
box wiring by placing the bare ends of the wires side by
side and then securing with a wire nut. Test that the
connection is secure by pulling on the wire nut. Connect
in this order:
• GREEN leads from mounting plate and downrod
assembly of fan to GROUND conductor of power
source. Secure with wire nut.
• WHITE wire from fan to white NEUTRAL wire in
ceiling fixture outlet box. Secure with wire nut.
• BLACK power wire from fan to black POWER wire
in ceiling outlet box. Secure with wire nut
NOTE: If the color of your ceiling wires differs from
that described, consult an electrician.
CANOPY ELECTRICAL CONNECTIONS
Step 10a. Tuck the wires into the canopy with the wire
nuts pointed upwards, so that the WHITE and BLACK
wires are on opposite sides of the canopy and all wires are
clear of the canopy opening.
Step 10b. Install canopy hatch with the last canopy screw
and lock washer using the provided screwdriver. To do
this, tilt the fan body away from the hatch opening.
Tighten the screws firmly.
Step 10c. Straighten the fan, then check to ensure that
there is no movement between the canopy and the ceiling
or the Perma•Lock
™
downrod and the ball assembly.
CANOPY HATCH INSTALLATION
Wire Nut
2 Black
Wires
2 White
Wires
3 Green
Wires
Canopy
Canopy
Hatch
Washer
Canopy
Screw
SWITCH HOUSING INSTALLATION
SWITCH HOUSING HARDWARE (not to scale)
Switch Housing
Mounting Plate
Screw Pack E:
Motor & Switch
Housing Mounting
Plate Screws (6)
Switch Housing
Mounting Plate
No Light Cap Adapter
Plate & Finial
Switch Housing
Cap
Motor Housing
Screws
Step 11a. Using screws from Screw Pack E and the provided
screwdriver, install two screws into the motor bottom housing
as shown.
Step 11b. Route the light connector wires through the switch
housing mounting plate as shown.
Step 11c. Align the switch housing mounting plate with the
two screws in the motor bottom housing and turn
counterclockwise to align the keyhole slots in the plate with
the two screws as shown.