Installation Guide

Table Of Contents

2、The size of counter basin's hole as above.

1. Ensure that the water supply below your sink is

completely shut off by turning the shutoff valves

all the way to the right.

Tip: Place a small bucket below your workspace

to catch any water that may drip during the

installation process.

taking apart

3、hot and cold water switches , twisting the nut

with hexagonal key, disassenbling the handle

bar, then taking out the valve core from the

below.

PAGE 1
. Ensure that the water supply below your sink is completely shut off by turning the shutoff valves all the way to the right. Tip: Place a small bucket below your workspace to catch any water that may drip during the installation process. 2、The size of counter basin's hole as above. 3、hot and cold water switches , twisting the nut with hexagonal key, disassenbling the handle bar, then taking out the valve core from the below.
PAGE 2
4、taking apart the tee and the hex nut under water oulet components. 7、Finally connecting the double head tube. taking apart cold water hot water 5、Firstly rotating the switch shell into the switch base, then screwing down the switch component with hex nut and reload the handle bar. hot water switch H (red) 8、 Connect the braided water lines attachedto the spout to their proper outlets on the side of each valve stem, as shown. Apply thread sealant or plumber's tape to each threaded connection.