Installation Guide

CARE INSTRUCTIONS
DO NOT:
WALL-MOUNT BATHROOM FAUCET
Installation instruction
MB/BN/BG/CH/ORB
1. Before installation, the sundries at the connection must be
removed to avoid blockage or water leakage;
2. Correctly connect the water inlet of the tap according to the
figure (as shown in the figure);
3. The highest hot water temperature is not higher than 80ºC
4. If you need to use other connection methods, contact the
supplier first.
Mark the location of screw holes on
the wall, drill holes and install the
inlet body
Hot Cold
The bottom of the main body is flat with the inner wall,
and the decorative cover is flat with the tile face
In the process of burying the wall, please do not
remove the protective sleeve to avoid bumping
the copper sleeve
Ceramic tile
surface
In the
wall
RECOMMENDED TOOLS
Plumber's
putty
Thread seal
tape
Included