Installation Guide

1. Thread two screws to the mounting strap, and secure
with two lock nuts. Adjust the length of the screws if
necessary.
2. Attach the mounting strap to outlet box by using two
mounting screws.
3. Rod connections:
a. Thread the fixture wire from the fixture through the
lower rod, and then secure the lower rod onto fixture
using the nipple.
b. Thread the fixture wire through the upper rod, and
then secure the upper rod onto the lower rod using
the nipple.
The height can be adjustable to 22", 31-1/2" or 41"
by using the rods.
4. Thread the fixture wire through the canopy kit, then secure
the rod assembly to the set nipple of the canopy kit.
5. Pull out the outlet wires and the house grounding wire from
the outlet box. Make wire connections using the wire nuts:
---The black wire from fixture to the black wire from power
source.
---The white wire from fixture to the white wire from power
source.
---Attach the fixture grounding wire to the mounting strap
with the green grounding screw. Then connect it to the
house grounding wire with the wire nut.
Carefully put the wires back into the outlet box.
6. Attach the canopy to the mounting strap by inserting the
screws, and secure it with two bolt nuts.
7. Attach the glass shade to the glass holder, then secure it
with the socket ring.
8. Install a bulb (not included). See relamping label at socket
area or packaging for maximum allowed wattage.
9. Turn on the power at the main fuse or circuit breaker box.
Bolt Nut
Canopy Kit
Outlet Box
House Grounding Wire
Wire Nut
Screw
Mounting Strap
Green Grounding Screw
Lock Nut
Mounting Screw
Upper Rod
Lower Rod
Nipple
Nipple
Set Nipple
Fixture Wire
071015
Fixture
Glass Shade
Glass Holder
Socket Ring
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THIS INSTRUCTION.
AL-PDD060