Installation Guide

1. Thread two screws through the cross bar, then secure them with two lock nuts. Adjust the length of
the screws if necessary.
2. Attach the cross bar to the outlet box by using two mounting screws.
3. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire connections
using the wire nuts:
---The black wire from the fixture to the black wire from the power source.
---The white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the cross bar with the green grounding screw. Then connect
it to the house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
4. Attach the pan to the cross bar by inserting the two screws, then secure it with the bolt nuts.
5. Install bulbs (not included), see relamping label at socket area or packaging for maximum allowed
wattage.
6. Screw the nipple into the coupling, then secure it with a washer and hex nut.
7. Attach the frame to the pan by inserting the nipple, then secure it with the cap and finial.
8. Turn on the power at the main fuse or circuit breaker box.
Pan
Socket
Coupling
Washer
Hex Nut
Nipple
Finial
Side Glass Panel
Frame
House Grounding Wire
Outlet Box
Wire Nut
Cross Bar
Lock Nut
Green Grounding Screw
Bolt Nut
Mounting Screw
Fixture Grounding Wire
Screw
Cap
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
CC55414 / CC55514 / CC55614 / CC55714
100325
Bulb Type A Max.60W
(not included)
CC55414
CC55514
CC55714