Installation Guide

Installation Steps :
INSTALLATION INSTRUCTIONS
IMPORTANT:
BEFORE YOU BEGIN INSTALLING THE FAN, CAREFULLY READ ALL INFORMATION ON THE SEPARATE
SHEET "SAFETY INSTRUCTIONS" AS WELL AS THE FOLLOWING "INSTALLATION INSTRUCTIONS". IF IN
DOUBT, CONSULT A QUALIFIED ELECTRICIAN.
SAVE ALL INSTRUCTIONS.
NOTE: The fan weight is 17.8 lb (8 kg). Be sure the outlet box you are using is securely attached to the building
structure and can support the full weight of the fan. Failure to do so can result in serious injury.
Fig.1
Turn OFF the electric power at the
main fuse or circuit breaker box.
Tighten the hanger bracket to the outlet box with two mounting screws.(Make sure
the outlet box is securely installed so that it will be able to support at least the
fan weight.) Attach the safety cable hook to the ceiling with the dry wall screw and
washer, and make sure the safety cable hook is covered by the fan canopy.
WARNING: MOUNT ONLY TO AN OUTLET BOX MARKED "ACCEPTABLE FOR
FAN SUPPORT"!
Fig.5.Fig.2.
Ceiling
Hanger Bracket
Ceiling Joist
Wood Member
(2" x 4" Approx.)
Junction Box
Washer
Safety Cable Hook
Dry Wall Screw
Ceiling
Hanger Bracket
Ceiling Joist
Wood Member
(2" x 4" Approx.)
Junction Box
Fig.3.
Hanger Pin
Lock Pin
Housing
( For downrod mount only):
Remove the Lock Pin and take off
the Hanger Pin.
Fig.4
( For downrod mount only):
Insert the Downrod into the Collar.
Slide Hanger Pin through holes of
Collar and Downrod.
Fig.6
Fig.7
Lock Pin
Collar Screws
( For downrod mount only):
Insert and tighten the two Collar
Screws. Slide Lock Pin into Hanger
Pin until it locks into position.
Slot
Chip
Hanger Bracket
Fig.8
( For ceiling mount only):
Attach the canopy to the housing
with three ceiling mount screws.
Go to Fig.9 for the next step.
Hanger Pin
Motor Wires
Motor Wires
Downrod Stand
Cover
Downrod
Canopy
Fig.5
(For downrod mount only):
Hang fan on hanger bracket, and
rotate the downrod until the chip on
the hanger bracket snaps into the slot
on the hanger ball.
Note: For slope ceiling installation,
make sure the slot of hanger ball and
the chip of hanger bracket are toward
the floor.
( For downrod mount only):
Slide canopy and downrod stand
cover onto downrod, as shown;
Then thread motor wires through
downrod.
Page 5 / 9
F A N C O
141016