Installation Guide

Attach the canopy to the hanger
bracket, and then secure it with
four screws and washers.
Screw
Hanger Bracket
Washer
Canopy
Fig.11
Attach blades to blade holders by
using blade screws and washers.
Blue
Green (Ground)
Fig.9
Secure blade holders to the motor
with motor screws and washers.
NOTE: Before installing blade
holders to the motor, please
remove the plastic inserts.
Fig.12
Blade
Blade Holder
Blade Screw
Washer
Fig.13
Fig.14
Make wire connections:
1). The white motor wire to the white wire from the outlet box with a wire nut.
2). The black motor wire and blue wire to the black wire from the outlet box with
a wire nut.
3). The ground wire from the outlet box to the ground wire from the motor
with a wire nut.
*** After making the wire connections, the wires should be spread apart with the
grounded wires on one side of the outlet box and the ungrounded wires on the
other side of the outlet box.
*** After the connections have been made, the wires should be turned upward and
pushed carefully up into the outlet box.
Assembly without fan light
Make sure the wires of the fan light
in the switch box are capped with
wire nuts. Secure the switch box
cover with the switch box screws.
Note: To install the fan light, skip
this step and proceed to Fig.15.
Hang the safety cable into the safety cable hook.( See Fig.10)
Fig.10
Safety Cable Hook
Safety
Cable
Plastic Insert
Motor Screw
Blade Holder
Switch Box
Screw
Page 6 / 9
F A N C O
141016