Installation Guide

1. Rod Connections:
a. Thread the fixture wire from the fixture through the 6” rod and
lower rod, assemble the two rods together, then secure the
assembly rod onto fixture using the threaded pipe.
b. Thread the fixture wire through the middle rod, and then secure
the middle rod onto the lower rod using the threaded pipe.
c. Thread the fixture wire through the upper rod, and then secure
the upper rod onto the middle rod using the threaded pipe.
The height can be adjustable to 10-3/4", 16-3/4", 22-3/4",
28-3/4", 34-3/4", 40-3/4"or 46-3/4" by using the rods.
2.
Thread the fixture wire through the coupling kit, collar, canopy, then
secure the rod assembly to the coupling kit. secure the Threaded
nipple by tightening the set screw.
3. Thread the fixture wire through the nipple-1, hex nut and mounting
strap. Install the hex nut onto one end of the nipple-1 leaving about
3/8” (10mm) thread exposed. Install same end of nipple-1 by screwing
into coupling kit, secure nipple-1 by tightening hex nut.
4. Attach the nipple-1 to the mounting strap, then secure it with
hex nut.
5. Attach the mounting strap to outlet box by using two mounting
screws.
6. Pull out the outlet wires and the house grounding wire from the
outlet box. Make wire connections using the wire nuts:
---The black wire from fixture to the black wire from power
source.
---The white wire from fixture to the white wire
from power source.
---Attach the fixture grounding wire to the mounting
strap with the green grounding screw. Then
connect it to the house grounding wire with
the wire nut.
Carefully put the wires back into the outlet box.
7. Attach the canopy to the mounting strap, and
secure it with collar.
8.
Attach the glass shades onto the glass holders,
secure it with the spacer and socket rings.
9. Install bulbs (not included). See relamping label
at socket area or packaging for maximum allowed
wattage.
10. Attach the anti-knocking glass onto the socket.
11. Turn on the power at the main fuse or circuit
breaker box.
Warning: The lamp is hot. Do not touch the bulb with fingers. It's extremely
important to keep the bulb clean. Any dust or sweat may damage the bulb
immediantely. If accidently touched or dirty, clean with fabric carefully.
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
H0002
120221
Contents of Spare Parts:
Assembly Kit
(1 SET)
(4399MM)
Bulb
(4 PCS)
(8050HL)
Anti-Knocking Glass
(4 PCS)
(9107FR)
Glass Shade
(4 PCS)
(9269FO)
Collar
Canopy
Outlet Box
House Grounding Wire
Wire Nut
Nipple-1
Mounting Strap
Green Grounding Screw
Hex Nut
Mounting Screw
Upper Rod
Middle Rod
Lower Rod
Threaded Pipe
Fixture Wire
6” Rod
Fixture
Glass Shade
Glass Holder
Socket Ring
Bulb G 9 Max.75W
(Included)
Coupling Kit
Fixture Grounding Wire
Hex Nut
Anti-Knocking Glass
Spacer
Threaded Pipe
Socket
Threaded Pipe
Set Screw
Threaded Pipe