Installation Guide

1. Attach the threaded pipe to the mounting strap, then secure it with a
washer and hex nut.
2. Attach the mounting strap to the outlet box by using two mounting screws.
3. Secure the top loop to the threaded pipe.
4. Secure the loop onto the stem of the fixture, thread fixture wires through
threaded end of loop first.
5. Adjust the lower arms of the fixture according to the drawing of the package.
Important:
a. The arms should be positioned with equal distances between them.
b. The arms should be fixed securely.
6. Take an upper arm, attach its one end to the fixture, secure it with a bolt nut
attach its the other end to lower arm, secure it with a bolt nut . See illustration
for correct position. (don’t reverse two ends of upper arm). Repeat with the
other upper arms.
7. Connect the chain:
- Determine length of chain needed to achieve desired fixture height. (To remove
excess chain section, use pliers to bend link open.)
- Weave the fixture wires and fixture grounding wire through the chain, collar and canopy.
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
H0131 / H0132
Fixture
Bolt Nut
Bolt Nut
Stem
Glass Shade
Socket Ring
Lower Arm
Glass Holder
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Hardware Package (included):
141127
Upper Arm
Socket
Turn off the power at fuse or circuit box.
Installation Steps
Loop Lock(K)
Loop Lock(K)
Outlet Box
House Grounding Wire
Wire Nut(E)
Fixture Wire
Fixture Grounding Wire
Mounting Strap(A)
Green Grounding Screw(C)
Mounting Screw(B)
Threaded Pipe(F)
Canopy(G)
Hex Nut(D)
Washer(J)
Collar(I)
Chain(L)
Loop
Bulb Type A Max.
100W(not included)
Top Loop(H)
Mounting Strap (A)
Mounting Screw (B)
Green Grounding
Screw (C)
Hex Nut (D)
Wire Nut (E)
Canopy (G)
Top Loop (H)
Collar (I)
Threaded Pipe (F)
Washer (J)
Loop Lock (K)
Chain (L)