Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
H0192
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Turn off the power at fuse or circuit box.
Installation Steps
Ball Nut (G)
Outlet Box
House Grounding Wire
wire connector (F)
Fixture Mounting Screw (D)
Mounting Strap (A)
Lock Nut (E)
Green Grounding Screw (B)
Mounting Screw (C)
Hardware Package (included):
Mounting Screw (C)
Lock Nut (E)
Wire Connector (F)
Ball Nut (G)
Mounting Strap (A)
Fixture Mounting
Screw (D)
Green Grounding
Screw (B)
171104
Fixture Canopy
Upper Rod
Threaded Pipe
Middle Rod
Lower Rod
Socket
Glass Shade
Socket ring
Type A Max.60 W
(not included)
1. Thread two fixture mounting screws through the mounting strap, and then
secure with two lock nuts. Adjust the length of the fixture mounting screws
if necessary.
2. Attach the mounting strap to the outlet box by using two mounting screws.
3. Attach the threaded pipe to the coupling of the main fixture, secure it with
a washer and hex nut. Adjust the length of the threaded pipe if necessary.
4. Attach the tube, cap and metal part onto the coupling by inserting the
threaded pipe, and then secure with the metal part.
5. Rod Connections:
a. Thread the fixture wire from the fixture through the lower rod, and then
secure the lower rod onto fixture using the threaded pipe.
b. Thread the fixture wire through the middle rod,
and then secure the middle rod onto the lower
rod using the threaded pipe.
c. Thread the fixture wire through the upper rod,
and then secure the upper rod onto the middle
rod using the threaded pipe.
d. Thread the fixture wire through the loop and
fixture canopy, and then secure the loop onto
the upper rod using the threaded pipe.
Note: Length adjustable from 10-5/8" to 64-5/8".
Use fewer rods if shorter length is desired.
6. Take a loop lock, open the locking tube, and then
hook it onto the loop of fixture canopy and the loop
of upper rod. Close back the locking tube of the loop lock.
7. Pull out the outlet wires and house grounding wire from the outlet box. Make wire connections using the wire connectors:
---The smooth wire (marked) from the fixture to the black wire from the power source.
---The ridged wire (unmarked) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with the green grounding screw. Then connect it to the house
grounding wire with a wire connector.
Carefully put the wires back into the outlet box.
8. Attach the fixture canopy to the mounting strap by inserting the fixture mounting screws, and then secure it with two ball
nuts.
Loop
Loop Lock (H)
Loop Lock (H)
metal part
Metal Pad
Cap
Tube
Hex Nut
Coupling
Washer