User manual

ManualsBrandsCasio ManualsWatch5289

Operation Guide 5289

E-9

E-23 Conﬁ guring Home City Settings

E-23 To conﬁ gure Home City settings

E-26 To switch between standard time and summer time

E-28 Conﬁ guring Current Time and Day Settings

E-28 To change the current time setting

E-31 To change the current day setting

E-35 Checking the Current Time in a Different Time Zone

E-36 To view the time in another time zone

E-39 To swap your Home City and World Time City

E-40 Using the Stopwatch

E-41 To enter and exit the Stopwatch Mode

E-42 To perform an elapsed time operation

E-42 To perform lap time measurement

E-44 To recall lap data

E-8

Contents

E-2 About This Manual

E-3 Using the Crown

E-6 Things to check before using the watch

E-11 Charging the Watch

E-13 To check the current power level

E-18 To recover from the sleep state

E-19 Mode Reference Guide

E-20 To determine the watch’s current mode

E-20 To return to the Timekeeping Mode from any other mode

E-21 To select a mode

E-22 Timekeeping

E-7

2. Check the Home City.

Use the procedure under “To conﬁ gure Home City settings” (page E-23) to conﬁ gure

your Home City.

3. Set the current time.

See “Conﬁ guring Current Time and Day Settings” (page E-28).

The watch is now ready for use.

E-6

Things to check before using the watch

1. Hold down C at least two seconds to enter the Timekeeping Mode, and

then observe the movement of the

Second Hand.

Is the

Second Hand moving smoothly at one-second intervals?

Is the

Second Hand moving at

two-second intervals or is it stopped

completely?

Go to step 2.

The watch is charged. For details

about charging, see “Charging

the Watch” (page E-11).

Power is low. Charge the watch by

placing it in a location where it is

exposed to light. For details, see

“Charging the Watch” (page E-11).

YES

E-5

High-speed Cancel

Rotate the crown towards you or press any button.

Note

If you do not perform any operation for more than two minutes after pulling out the

crown, crown operations will become disabled automatically. If this happens, push

the crown back in and then pull it out again to re-enable crown operations.

You can use high-speed hand movement when conﬁ guring time settings in the

Timekeeping Mode, Alarm Mode, Countdown Timer Mode or home position

adjustment.

High-speed hand movement is forward only. There is no high-speed backward

hand movement.

Button operations become disabled after you perform a crown operation. If this

happens, rotate the crown slightly. This should restore button operations.

E-4

When rotating the crown to move the hands of the watch, you can use the operations

described below to move the hands at high speed. There are two high-speed hand

movement speeds. High-speed 2 is the fastest.

High-speed 1

With the crown pulled out, rotate it rapidly away from you three

times.

High-speed 2

After starting the High-speed 1 operation, rotate the crown

rapidly away from you three more times.

E-3

Using the Crown

The crown of this watch is a screw in lock crown. Before using

the crown, you must ﬁ rst rotate it towards you to loosen it.

After performing crown operations be sure to press the crown

in lightly as you screw it back in.

Important!

To maintain water resistance and avoid impact damage x

to the crown, be sure to screw it back in when you are not

using it.

The illustrations below show the different crown operations.

Pull out Rotate Push in

Crown

Loosen

E-2

About This Manual

Operations are performed using the watch’s crown, and

the three buttons indicated by the letters A, B and C in

this manual.

Hands and Indicators

Hour Hand

Second Hand

Minute Hand

Upper Dial Hand: Indicates a time, in 24-hour format,

depending on the current mode.

Lower Dial Hand: Points to the day of the week.

Day Indicator

This User’s Guide uses numbers shown above to identify

watch hands and indicator.



@>B

E-1

ENGLISH

Congratulations upon your selection of this CASIO watch.

Note that the product illustrations in this manual are intended for reference only, and so

the actual product may appear somewhat different than depicted by an illustration.

MA1206-EA

#!3)/#/-054%2#/,4$

Summary of content (7 pages)

PAGE 1
MA1206-EA Ú #!3)/ #/-054%2 #/ ,4$ Operation Guide 5289 ENGLISH Congratulations upon your selection of this CASIO watch. x Note that the product illustrations in this manual are intended for reference only, and so the actual product may appear somewhat different than depicted by an illustration. E-1 About This Manual Using the Crown Operations are performed using the watch’s crown, and the three buttons indicated by the letters A, B and C in this manual.
PAGE 2
Operation Guide 5289 E-45 Using the Countdown Timer E-46 To specify the countdown start time E-47 To perform a countdown timer operation E-47 To stop the alarm E-48 Using the Alarm E-49 To change the alarm time setting E-51 To turn the alarm on or off E-51 To stop the alarm Charging the Watch The face of the watch is a solar panel that generates power from light. The generated power charges a built-in rechargeable battery, which powers watch operations. The watch charges whenever it is exposed to light.
PAGE 3
Operation Guide 5289 Selecting a Mode With this watch, everything starts from the Timekeeping Mode. To determine the watch’s current mode Check what the b Lower Dial Hand is indicating as shown under “To select a mode” (page E-21). To return to the Timekeeping Mode from any other mode Hold down C for at least two seconds. To select a mode Each press of C will cycle between modes. The currently selected mode is indicated by the b Lower Dial Hand.
PAGE 4
Operation Guide 5289 4. Rotate the crown to adjust the time (hour and minute) setting. x See “Using the Crown” (page E-3) for information about high-speed hand movement. x The v Upper Dial Hand is synchronized with the z Hour Hand. x When adjusting the setting, check to make sure that the v Upper Dial Hand correctly indicates an a.m. time or p.m. time.
PAGE 5
Operation Guide 5289 Using the Stopwatch Hands and Indicators + B @ You can use the Stopwatch Mode to measure elapsed time and lap times, and to recall lap times. Up to 10 lap times can be stored in memory. There is also memory to record the fastest lap time. Though no more lap times are stored after 10 times are in memory, the fastest lap time continues to be updated as required. Starting a new elapsed time operation clears all of the memories (including fastest lap time).
PAGE 6
Operation Guide 5289 3. Rotate the crown to set the alarm time. x The z Hour Hand will also move. x See “Using the Crown” (page E-3) for information about high-speed hand movement. 4. Press C to switch to the hour setting mode. x The z Hour Hand will move slightly left and right to indicate the z Hour Hand setting mode. x Check the 24-hour time indicated by the v Upper Dial Hand to see if the current setting is a.m. or p.m. 5. Rotate the crown to adjust the hour setting only.
PAGE 7
Operation Guide 5289 Specifications Accuracy at normal temperature: ±15 seconds a month Timekeeping: Hour, minutes (hand moves every 10 seconds), seconds, day Calendar system: Full Auto-calendar pre-programmed from the year 2000 to 2099 Other: Home City code (can be assigned one of 29 city codes and Coordinated Universal Time); Daylight Saving Time (summer time) auto switching / Standard time World Time: 29 cities (29 time zones) and Coordinated Universal Time Other: Daylight Saving Time (summer time) / Sta