User`s guide

E-24

Handling the Hand Belt

The hand belt is attached to the terminal. Remove it if it is not necessary.

To remove the hand belt

1. As shown in the ﬁ gure, pull out the metal part of the hook while pressing down the

protrude part that has a small dimple on it.

2. Loose the hook-loop fastener and then pull out the belt through the hand belt hook as

shown in the ﬁ gure.

To attach the hand belt

1. Thread one end of the hand belt through the hand belt hook. Then fold it back and set

the belt in proper length by adjusting the hook-loop fastener.

2. As shown in the ﬁ gure, align the metal part of the hand belt hook in line with the

installation position on the terminal and then snap it into the ditch. Make sure that the

metal part is ﬁ rmly seated.