Operating Instructions

SETTINGS & TOOLS
G’zOne TYPE-S 151 G’zOne TYPE-S 150
Select Key [OK].
NOTE
The default Lock Code is the last 4 digits of your mobile
telephone number.
3. Press Reset Default.
4. Press Center Select Key [OK] after reading the
following warning message, the confirmation message
appears : Preference Settings Will be set to factory
defaults. Press Center Select Key [OK] to
continue.
5. Press Navigation Key up or down to select
Revert, then press Center Select Key [OK].
A confirmation message appears before the phone
resets itself.
6.5 System Select
Allows you to set your phone to search or roam for
another network when you are not in your home area.
Leave this setting as the default unless you want to alter
system selection as instructed by your service provider.
1. Press Center Select Key [MENU],Navigation Key
right twice for SETTING & TOOLS,
Phone Settings, System Select.
2. Press Navigation Key up or down to select one
of the following setting, then press Center Select Key
[OK].
• Home Only: Only within your home area or home
affiliated area.
• Automatic: Scan the radio channels based on the
Automatic setting.
NOTE
If you select the PTT Mode On, you cannot change this
setting.
6.6 NAM Selection
To select the phone’s NAM (Number Assignment
Module) if the phone is registered with multiple service
providers:
1. Press Center Select Key [MENU],Navigation Key
right twice for SETTING & TOOLS,
Phone Settings, NAM Selection.
2. Press Navigation Key up or down to select one
of the following setting, then press Center Select Key