User's Manual

11
These keys can be assigned any function other than barcode reading.
The following are the initial default settings.
10 Function Keys
F1
F2
F3
F4
: Deletes one character to the left.
: Inputs a hyphen (-).
: Inputs a period (.).
: Toggles to switch between numbers and alphabets.
11 IR Port This port is used for IR communication with another Handheld
Terminal or Bridge Satellite Cradle.
12 Power Contacts Contact point for supplying power from Bridge Satellite Cradle and
Cradle-type Battery Charger.
13 CLR Key Press to clear all key inputs.
14 Fn Key Press this key and then a function key or number key to configure
settings or to run previously registered applications.
15 PC Card Slot For insertion of a separately available PC card.
16 USB Port For connection to a computer or other device using a USB cable.
17 Headset Jack For connection of a commercially available headset (2.5mm).
18 Battery Pack Cover Lock
Switches
Slide these switches to lock and release the battery pack cover.
19 R Trigger Key Press to perform a code read operation. This is also pressed to perform a
full reset.
20 L Trigger Key Press to perform a code read operation. This is also pressed to cancel a
full reset.
21 Wrist Strap Hole Connect the wrist strap here.
C-MOS Imager (C-MOS
Imager models only)
Reads 1D bar codes and 2D codes. 22
Reader Port (Laser Scanner
models only)
Reads 1D bar codes.
23 Reset Switch Press to reset the Handheld Terminal.
24 CF Card Slot Unit Terminal For connection of a separately available CF Card Extension Unit.
25 Battery Pack Cover Covers the compartment that holds the battery pack.