User manual - Scripting_Guide

NAURTECH SMART CLIENTS FOR WINDOWS CE AND POCKET PC
CETerm Scripting Guide Page 79
CODABAR SYMBOLOGY PROPERTIES
Codabar specific symbology properties are unique for each session. Symbology
properties begin with “sessionX.scanner.codabar” where X is 1 through. For
example “session4.scanner.codabar.clsiediting”. If no ‘X’ value is found, the
currently active session number is used.
NOTE: If you are changing the symbology properties for the currently active
session, you must call “CETerm.PostIDA(
“IDA_SCAN_APPLYCONFIG”, 0 ) for the changes to take effect.
WARNING: Not all properties are applicable to all hardware devices. Different
devices may use different names to refer to the same parameters.
You should look at the settings available in the CETerm configuration
dialogs to determine if the property is appropriate and what values it
may accept.
Last Property Level Description
clsiediting CLSI editing is enabled. T/F
notisediting NOTIS editing is enabled. T/F
startstop Start/Stop digit modes. Not all modes apply to all
devices. See CETerm configuration for values on a
specific device. discard, none, abcd, dc1-dc4,
lowerabcd, abcd/tn*e, aa, bb, cc, dd, any