User manual - WirelessGuide_XJHST_E

System Admin > Change Password

Remote on Specifies whether the projector can be turned on via wired LAN while the projector

is in standby (projector off with power being supplied).

Enable: Power on enabled.

Disable: Power on disabled (initial default).

Important!

Performing an “Initialize Network Settings” operation or “Restore All

Defaults” operation with the setup menu will cause this setting to change to

“Disable”. If you are operating the projector using a wired LAN setting, be

sure to change this setting back to “Enable” after initialization. The “Remote

on” setting can also be changed on the projector using the setup menu. For

full details, see “Wired LAN Settings Main Menu (USB Port Models Only)” in

the User’s Guide on the CD-ROM that comes with the projector.

PJLink authentication Enables and disables PJLink connection authentication.

Enable: PJLink connection authentication enabled (initial default).

Disable: PJLink connection authentication disabled.

Show User Name Display Specifies whether the computer’s user name should appear on the projection

screen when projection starts from a computer connected to the projector via

wireless LAN.

Initial Default: On (User name displayed.)

Setting Name Description

New Password

Reinput password

For input of the new password when logging in to the System Admin page.

Initial Default: admin

Setting Name Description