DATA PROJECTOR XJ-350

Troubleshooting
112
Check the following items whenever you experience any problem with the projector.
POWER : Amber flashing J
Red steady
Power has turned off automatically because the lamp
cover is open. Perform the following steps.
1 After confirming that the POWER/STANDBY
indicator is lit red, unplug the AC power cord
and wait for about 60 minutes to allow the
projector to cool down.
2 Close the lamp cover.
) “To replace the lamp” (page 105).
3 Plug the AC power cord back in, and turn on
the projector again.
TEMP : Amber flashing
POWER : Amber flashing J
Red steady
Internal memory error.
After confirming that the POWER/STANDBY indicator
is lit red, unplug the AC power cord, wait for about
60 minutes to allow the projector to cool down, and
then take it to your retailer or nearest authorized
CASIO Service Center.
TEMP : Red flashing (2-
second interval)
POWER : Green steady U
It is time to replace the lamp.
Replace the lamp following the steps under
“Replacing the Lamp” on page 102.
LAMP : Red flashing
(1-second interval)
POWER : Amber flashing J
Red steady
The allowable life for the lamp has been exceeded,
and the projector will not turn on.
Replace the lamp following the steps under
“Replacing the Lamp” on page 102.
LAMP : Red steady
Projector Troubleshooting
Problem Cause and Recommended Action See page
The projector does not turn
on when I press the [ ]
(power) key.
If the POWER/STANDBY indicator is not lit, the
AC power cord may not be connected correctly.
J Make sure the AC power cord is connected
correctly to the projector and the power outlet.
38
If the TEMP or LAMP indicator remains flashing
or lit, it means some type of error has occurred.
J See “Error Indicators”.
111
Indicator Alert Description