DATA PROJECTOR XJ-350

Getting Ready

3. If the projector’s lens cover is closed, open it.

4. Press the [ ] (power) key.

z This causes the POWER/STANDBY indicator to flash green, which indicates that the

projector is warming up. After a short while, the start up screen will be projected (warm

up is still in progress).

z After warm up is complete, POWER/STANDBY indicator stops flashing and remains lit

green, and the projector starts projecting an image from the device connected to it. It

normally takes about 60 seconds from the point that warm up starts until an image is

projected from the connected device.

z A “Language” window will be projected the first time you turn on the projector. Use the

procedure under “Specifying the Display Message Language” on page 40 to configure

the language settings.

z You can configure the startup screen so it shows a custom logo you created yourself, or

so nothing appears at startup. For details, see “Option Settings J Custom Logo Settings”

on page 92 and “Screen Settings J Startup Screen” on page 82.

z If the projector is configured for low-noise mode operation, the LAMP indicator lights

green when warm up starts. See “Option Settings J Low-noise Mode” on page 90 for

information about the low noise mode.

z For details about projection operations, see “Projecting onto a Screen” on page 43.

Startup screen Input image projection