Installation Guide

For Customer Assistance:

www.evolutionlightingllc.com

Made In China

Installation

Installing the xture

Installing the mounting bracket

Making the electrical connections

Installing the light bulbs

Install ve 60 Watt E12 Type B Bulbs or CFL or LED

equivalent (not included).

Restore electrical power when complete.

Carefully unpack and lay all parts on a clean, level surface.

Open the rst quicklink and remove the preassembled chain (E)

from the screw collar (B), unscrew the canopy nut (D) and detach

the mounting bracket (A) from the canopy (C).

Install the mounting bracket (A) to the junction box (not

included) with two junction box screws (AA).

Thread the screw collar (B) onto the preassembled tube on the

mounting bracket (A) and secure with the preassembled hex nut.

Make the connections to a 120V AC 60Hz circuit.

NOTE:

Attach the chain (E) through the canopy nut (D) and the canopy (C)

to the screw collar (B).

Weave the wires through the chain links (E) every 3 in., the canopy

nut (D), the canopy (C) and the screw collar (B) into the junction box.

Connect the cord with the ribbed surface to the white wire of the

supply circuit. Connect the half with the markings and smooth

surface to the black wire of the supply circuit. Wrap the bare copper

grounding wire from the xture around the green screw on the

mounting bracket (A), then connect it to the grounding conductor of

the supply circuit. Use U.L./CSA Listed wire connectors (BB) suitable

for the size, type and number of conductors. No loose strands or

loose connections should be present.

Secure wire connectors (BB) with U.L./CSA Listed electrical tape.

Secure the canopy (C) to the ceiling with the canopy nut (D).

Assemble the loop (F) onto the xture assembly (G).

Adjust the chain (E) length by removing links at a point best

suited for the location and required distance from the ceiling,

then reattach the chain (E) to the loop (F) with quicklink.