Full Product Manual

United States
Tel: [phone]
800.816.7809
Fax: [phone]
Technical Services
Tel: [phone]
www.tnb.com
G-83
Shield-Kon
®
Shield Termination System
Wire Termination — Sta-Kon
®
Wire Termination & Insulation
Select the connectors
you need quickly!
RSK-LEHRE Gauge
The choice of the appropriate connector and die set mainly depends on the
size of the shielded cable. The selection can be done very quickly with the
RSK-LEHRE gauge.
Remove the outer jacket from the shielded cable, making
the shielding visible.
Insert this stripped end of the cable into the slots located
around the gauge. The correct slot will be found when the
cable can slide only inthe upper part of the slot. If the
cable can slide completely to the bottom of the slot, you
should try with the smaller adjacent slot.
Once the appropriate slot is found, the corresponding RSK
connector is defined by the color of the strip around the
slot, whereas the corresponding plastic die set is given by
the number marked below the slot (for the metal die set,
add prefix “D” to this number).
The table on page G-80 summarizes the different
combinations of connector/die set, as well as the size
ofground wire that can beused.
CAT. NO. DESCRIPTION STD. PKG.
RSK-LEHRE Connector & Die Gauge 1
1
2
3
4
DIE
CAT. NO. DIE COLOR
SHIELD
DIAMETER (IN.)
FOR
CONNECTOR
STD.
PKG.
D-101A
Red
.050–.070 RSK 101 Red 1
D-101B .071–.089 RSK 101 Red 1
D-201C
Blue
.090–.100 RSK 202 Blue 1
D-201D .101–.118 RSK 202 Blue 1
D-201E .119–.131 RSK 202 Blue 1
D-201F .132–.143 RSK 202 Blue 1
D-301G
Yellow
.144–.162 RSK 301 Yellow 1
D-301H .163–.185 RSK 301 Yellow 1
D-301J .186–.201 RSK 301 Yellow 1
D-401K
Green
.202–.230 RSK 401 Green 1
D-401L .231–.250 RSK 401 Green 1
D-401M .251–.275 RSK 401 Green 1
D-401N .276–.300 RSK 401 Green 1
Order multiple is std. pkg.
Metal Dies for ERG740
• For mass production and medium to high volumes
• Made of hardened steel — does not wear
• Only for the ERG740 hand tool
• The Product Ref. is engraved on the upper part
and on the lower part of the die set
• Marked with a dot having the same color
asthecorresponding connector
• Weight — approximately 2.6 oz.