MSDS

Page 3/7
Safety Data Sheet
29 CFR 1910.1200
Printing date 06/03/2016 Reviewed on 06/03/2016
Trade name: SF10W-30 GASOLINE ENGINE OIL
(Contd. of page 2)
42.2.23
·
Methods and material for containment and cleaning up:
Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).
Dispose contaminated material as waste according to item 13.
Ensure adequate ventilation.
7 Handling and storage
·
Precautions for safe handling:
Ensure good ventilation/exhaustion at the workplace.
Open and handle receptacle with care.
For the general occupational hygienic measures refer to Section 8.
·
Information about protection against explosions and fires:
Keep respiratory protective device available.
·
Conditions for safe storage, including any incompatibilities
·
Requirements to be met by storerooms and receptacles:
No special requirements.
·
Information about storage in one common storage facility:
Not required.
·
Further information about storage conditions:
Keep receptacle tightly sealed.
8 Exposure controls/personal protection
·
Components with limit values that require monitoring at the workplace:
8002-05-9 Petroleum (96.699%)
PEL (USA) Long-term value: 2000 mg/m³, 500 ppm
REL (USA) Long-term value: 350 mg/m³
Ceiling limit value: 1800 mg/m³
*15-min.
TLV (USA) Rubber solvent TLV withdrawn
128-37-0 2,6-di-tert-butyl-p-cresol (0.8%)
REL (USA) Long-term value: 10 mg/m³
TLV (USA) Long-term value: 2* mg/m³
*as inhalable fraction and vapor
·
Additional information:
The lists that were valid during the creation were used as basis.
·
Based on the composition shown in Section 3, the following measures are suggested for occupational safety
measure.
·
Appropriate engineering controls:
Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing.
Wash hands before breaks and at the end of work.
Store protective clothing separately.
Avoid contact with the eyes.
Avoid contact with the eyes and skin.
See Section 7 for information about design of technical facilities.
·
Personal protective equipment:
·
Breathing equipment:
In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure
use respiratory protective device that is independent of circulating air.
·
Protection of hands:
Protective gloves
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
(Contd. on page 4)
USA