Operation Manual

ENG-9
ENG
3 mm
3 mm
3 mm
Continue
2-3. Adjust the distance to the magnet
1. Tilt the speed sensor so that the distance
between the cadence magnet and the CA-
DENCE side of the speed sensor is about 3
mm, and firmly secure it with the nylon ties.
2. Turn and adjust the sensor arm
so that the distance between the
wheel magnet and the sensor arm
is about 3 mm, and firmly tighten
the sensor screw.
2-4. Securing various parts
Firmly tighten the nylon ties, sensor screw
and magnet of the speed sensor, and check
for any loosening.
* For steel axle pedals, the cadence magnet
can be magnetically secured on the pedal
axle. Make sure to remove the double-sided
tape from the magnet when doing this.
3
Remove/Install the computer
Caution: When removing, hold the unit to prevent it from falling.
Sensor arm
Sensor
screw
(or)
Install Remove
Click
Slide the
computer
from the right
Holding the unit
Push outward
Cut extra length
of the nylon tie
with scissors.
Wheel magnet
Speed sensor
CADENCE side
Cadence
magnet