Operation Manual

ENG-19
ENG
SSE
M1/+
(Simultane-
ously press)
SSE
M2/-
(Simultane-
ously press)
Continue
Resetting the measurement data
To reset the measurement data (excluding the total time, total
distance, date, and clock) and the lap data, simultaneously
press the SSE button and the M1/+ or M2/- button on the mea-
surement screen.
* Resetting the measurement data saves the data automatically
on a file (page 26).
* The screen will freeze for about 2 seconds after resetting and
button operation is disabled; however, all measurements are
operating normally.
* The countdown distance (C.D.DST
→
) returns to the value
you set.
* Cannot reset for 5 seconds after pressing the LAP button.
Power-saving function
Transmission sleep mode
When the computer does not receive any signals for 5 minutes
from the speed sensor and the heart rate sensor, it will enter
the transmission-off status for each sensor to save battery
power. In the transmission-off status, any sensor signal cannot
be received. To restart the measurement, press the M1/+ or
M2/- button to recover from the transmission-off status.
The signal transmission status of each sensor can be checked by
the display of the relevant signal icon and the numeric value of “---”.
(flashing)
Receiving sensor signal (under opera-
tion)
(constant)
Stand-by for sensor signal (searching
for sensors)
off
Transmission sleep. Displays the sym-
bol “---”.
* Note that the computer does not start the measurement even
if you ride your bicycle in the transmission-off status, when
the auto-mode is on.
Power saving of the computer
When the computer does not receive any data for 10 minutes, it
will enter the power-saving mode, in which only the date/clock
is displayed.
By pressing any buttons except the AC recovers from the
power-saving mode, and the measurement screen appears.
You must press a button when the computer is in power saving
mode before it will start to measure any data.
(or)
Heart rate sensor
signal icon
Speed sensor
signal icon
Power-saving
mode