Operation Manual

ENG-32

M2/- M1/+

* When you use a computer for a single bicycle, set the tire circumference to

ID:1 (Sensor 1) only. When you use a computer commonly for two bicycles,

set the tire circumference of the second bicycle to ID:2 (Sensor 2).

* Changing to the measurement screen displays the sensor icon selected (

). Even when a computer is commonly used for two bicycles, the speed sen-

sor is recognized automatically and the measurement can be started (it may

take time to automatically recognize the sensor depending on the situation).

For details, refer to “Automatic recognition of the speed sensor ID” (page 4).

Searching the sensor ID

When moving the computer from one sensor to another or to use a different HR

chest strap, this operation must be performed.

* This unit requires the sensor ID. The computer cannot receive the sensor sig-

nal unless the sensor ID is synchronized properly.

* When you use the unit for the ﬁrst time (at factory default setting), each

sensor ID has been synchronized to the computer in the package; accord-

ingly, the following procedure is not required.

* To check the sensor ID, each sensor must be near the computer.

1. Press the MENU button on the measurement screen to

switch to the menu top screen.

Switch to the SENSOR-ID screen using the M1/+ and

M2/- buttons, and conﬁrm with the SSE button.

Menu top:

(Back)

Changing the menu:

M2/-

M1/+

(or)

Conﬁrm:

SSE

2. Select the sensor ID to be checked.

Select it from “HR (heart rate sensor)”, “SP1 (speed sensor

1)”, and “SP2 (speed sensor 2)” using the M1/+ and M2/-

buttons.

↔

SP1

↔

SP2:

M2/-

M1/+

(or)

* SP2 is used when a computer is commonly used for

two bicycles. By checking the ID of the second speed

sensor mounted to a second bicycle as SP2, the com-

puter is capable of recognizing two bicycles automati-

cally.