Operation Manual

ENG-33

ENG

Continue

3. Press the SSE button to start checking the ID.

Start searching:

SSE

While the value on the screen is changing, press the

RESET button on the sensor to be checked.

Speed sensor Heart rate sensor

When the heart rate or speed (cadence) is displayed with

“ID-OK” on the screen, synchronization is completed.

* The computer enters the search mode for 5 minutes

after starting the ID synch.

Press the SSE button in the search mode to cancel

the ID synch, and “ID-SKIP” is displayed. Unless a

sensor signal is received in 5 minutes, “ID-ERROR” is

displayed.

When “ID-SKIP” or “ID-ERROR” is displayed, the sen-

sor ID remains as it was before the ID synch.

4. Pressing the MENU button returns to the menu top

screen (SENSOR-ID screen), and conﬁrm the change(s).

Pressing it again returns to the measurement screen.

To the menu top/measurement screen:

(Back)

* When you use SP2, set the tire circumference of ID:2 (Sensor 2) according to

“Setting the tire circumference” (page 31).

RESET