Operation Manual

ENG-42
Trouble shooting
If a malfunction occurs, check the following before contacting CatEye or your retailer
for repair or service.
Trouble on display
Trouble Check Items Remedy
Display motion be-
comes slower.
Is the surrounding tem-
perature low (below zero
degree Celsius or 32 degrees
Fahrenheit)?
Temperatures below freezing may
result in slower screen response.
Data is not affected.
Flashes on the
screen.
The remaining battery capac-
ity for the computer is low.
Replace it with a new battery
(CR2032) immediately.
After replacement, be sure to
perform the restarting operation
(page 11).
“STOP!” lights up. The stop reminder function
(page 18) is activated.
It is cancelled, once you press the
SSE button to stop the measure-
ment.
Ignore this during measurement.
No displays appear. Is the battery for the com-
puter empty?
Replace it with a new battery
(CR2032).
After replacement, be sure to
perform the restarting operation
(page 11).
Meaningless display
appears.
Perform the restarting operation
(page 11).
Cannot measure the
trip speed (cadence)
Have you checked the sensor
ID?
Is the computer ID Synch’ed
with somebody else’s sensor?
Check the speed sensor ID (page
32) for SP1 (speed sensor 1)
or SP2 (speed sensor 2).
Is
turned on?
The computer cannot receive
any data when
is turned off.
Press the M1/+ or M2/- button to
recover from the transmission-off
status (page 19).
Check if the distance between
each sensor zone of the speed
sensor and the magnet is too
large.
In reference to “How to install the
unit on your bicycle” (page 7),
appropriately adjust the positions
of the corresponding magnet with
the sensor zone.
Check if each sensor zone of
the speed sensor is off the
center of the magnet.
Check if the computer is in
the transmission-off status,
or displays the power saving
screen.
Press any button on the computer
to return to the measurement
screen.
Is the battery for the speed
sensor empty?
Replace it with a new battery
(CR2032).