Operation Manual

ENG-8
2
Mount the speed sensor and magnet
2-1. Temporarily secure the speed sensor
1. Loosen the sensor screw on the speed
sensor using a Phillips screwdriver to check
that the sensor arm moves.
* Do not completely remove the sensor screw.
2. Attach the sensor rubber pad to the speed
sensor, locate the speed sensor on the left
chain stay as shown in the figure above, and
temporarily secure it with the nylon ties.
Caution:
Do not tighten the nylon ties completely at
this stage. Once a nylon tie is tightened, it
cannot be pulled out.
2-2. Temporarily secure the magnet
1. Temporarily secure the cadence magnet
inside the crank with nylon ties, so
that it faces the sensor zone on the
CADENCE side.
2. Turn the sensor arm, and temporarily
secure the wheel magnet to the spoke
that faces the sensor zone on the
SPEED side.
* When the speed sensor is not posi-
tioned appropriately in respect to the
two magnets (of CADENCE and SPEED),
move the speed sensor back and forth
so that it is positioned properly. After
you move the speed sensor, adjust the
position so that the two magnets face
the relevant sensor zone.
Wheel magnet
Cadence magnet
Speed sensor
Speed sensor
Sensor armSensor arm
Sensor
screw
Sensor
rubber pad
Nylon ties
Wheel magnet
Cadence magnet
Nylon ties
Sensor
zone