Installation Guide

Page 11
Upper chimney
Wall mount
range hood
Lower chimney
Motor housing
Electric circuit box
(Location varies)
6” Round duct (exhaust)
Re-circulating kit exhaust
(Re-circulating kit not shown)
Duct work and electric
wiring region
Note: Type “A” anchors are designed
for dry wall. Not to be used with any
other types of walls.
Calculate8. the height of the duct tube and extend approximately 6 inches longer than required, connect the lower
end of the duct tube to the range hood and the upper end to the vent system (or air diverter). Make sure the
main electrical supply remains disconnected then connect power plug to the electrical cord or wall plug.
Have one person carefully position both upper and lower chimneys on the range hood, let the second person 9.
slide the sides of the chimneys into the 1/16” gap. Fasten both chimneys with four Type “C” screws.
Install grease cup and aluminum lters then check the operation of the range hood.10.
Installation Overview
Mounting Bracket
A B
C
A B
C
Installation (Continued)
Hex Key
Qty: 1 PCS
(Optional with glass canopy)
Glass Canopy Screw
Qty: 4 PCS
(Optional with glass canopy)
Qty: 4 PCS
(For sheet rock only)
A
Qty: 4 PCS
B
Qty: 4 to 8 PCS
(Vary with model)
C
Air Movement Direction