Installation

Figure 1
NOTE: To avoid damage to your hood, prevent debris from entering the vent opening.
Determine and mark the center line on the ceiling where the range hood will be installed.
Make sure there is proper clearance within the ceiling or wall for exhaust vent.
Due to the weight and size of this unit, please make sure that the support system or
framework being used is stable and secure in the wall or ceiling.
Put a thick, protective covering over counter top, cook top or range to protect from damage
or dirt. Remove any hazardous objects around the area when installing.
Mark the locations of the support mounting bracket holes, ducting cutout (if used) and
power supply cable cutout on the ceiling. Use drill and saber saw or keyhole saw to cut
openings for power supply cable and ducting (see Venting Requirements and Electrical
Requirements, Pages 5-8).
If venting to the outside install vent system (see Venting Methods, Page 7). Use caulking to
seal exterior wall or roof openings.
Disconnect main electrical supply, prepare and run electrical wiring through ceiling or wall.
Leave approximately 12” of electrical cord hanging from the ceiling. DO NOT restore power
until installation is completed.
Disconnect power cord, remove the aluminum filter by pressing on the latch toward the
direction of solid arrow while holding the metal handle, gently pull the aluminum filter toward
the direction of dashed arrow as shown in Figure 1.
Remove the grease cup by sliding it sideway, see Figure 2 for location of the grease cup.
Set aside the aluminum filters and grease cup until the range hood is properly installed.
If the range hood comes with a glass canopy and has not already been mounted to the hood,
loosen the four canopy screws and washers from the hood top, carefully place the canopy on
the hood top, and loosely tighten the four canopy screws along with washers. DO NOT put
excessive pressure against the glass.
Preparations:
1.
2.
3.
4.
5.
6.
7.
8.
9.
Preparation
10.
Figure 2
Severe Injury
Rotating fan can cause severe
injury. Stay clear of fan when
power is present.
Assemble the duct adapter onto the range hood body. Place the duct adapter gasket into
the hollow perimeter of the rectangular side of the duct adapter; place the rectangular side
of the duct adapter over the range hood duct, aligning the screw holes; fasten the duct
adapter onto the range hood body using the supplied hardware: “G” screws.
11.
Pg 9