Installation

Copies of the standards listed may be obtained from:
* National Fire Protection Association
Batterymarch Park
Quincy, Massachusetts 02269
**
CSA International
8501 East Pleasant Valley Road
Cleveland, Ohio 44131-5575
To contact a qualified electrical installer.
To assure that the electrical installation is adequate and in conformance with National
Electrical Code, ANSI/NFPA 70 — latest edition*, or CSA Standards C22. 1-94, Canadian
Electrical Code, Part 1 and C22. 2 No. 0-M91 - latest edition** and all local codes and
ordinances.
Provide a circuit protected power service; preferably a Ground Fault Circuit Interrupter
("G.F.C.I."): 120-volt, 60 Hz, AC, with at least 5-amps of available service.
Enlist a qualified electrician to ensure the range hood and electrical lines are adequately
grounded and properly protected. NEVER electrically ground to a gas pipe.
Wire sizes (copper wire only) and connections must conform with the rating of the appliance
as specified on the model/serial rating label. Wire sizes must conform to the requirements of
the National Electrical Code ANSI/NFPA 70 — latest edition*, or CSA Standards C22. 1-94,
Canadian Electrical Code Part 1 and C22. 2 No. 0-M91 - latest edition** and all local codes and
ordinances. A U.L. - or C.S.A. - listed conduit connector must be provided at each end of the
power supply cable (at the range hood and at the junction box).
IMPORTANT: Observe all governing ordinances and local codes.
(Please consult with a qualified electrician for any electrical wiring)
It is the customer’s responsibility:
•
•
•
•
IMPORTANT: Save this Installation Guide for future reference and/or electrical inspector use.
The range hood should be connected with a circuit breaker protected power service.
Pg 8
Advanced Preparation
Electrical Requirements
range
hood by referring to Range Hood Operations, Page 13.
Place all supplied parts and required hardware on a flat, stable surface and verify the
presence of all supplied parts listed on Page 4.
Carefully remove the white plastic protective coat from the chimney covers and range hood.
Advanced Preparations:
1.
Familiarize yourself with the controls of the range hood
by reading through Range Hood Operations, Page 13.
2.
Place the range hood on a flat, stable surface. Connect
the range hood to a designated standard outlet (please
refer the product label for the suitable voltage of this unit)
and turn on the range hood. Verify all operations of the
3.
4.
Excessive Weight
Require three or more persons to
move and install this range hood.
Spinal or other bodily injuries
could occur if it is not followed.