Product Specs
Information on test modes and additional testing requirements.
Information on test modes:
The host manufacturer can use software for access to the test modes. Connected to the
device through the serial port of the host product and control the module. If it does not
work, then the host product manufacturer should coordinate with the module
manufacturer for access to test mode software.
The following provides guidance to host product when installing this module on
how they may verify the end product:
A. If the modular transmitter hasbeenfully tested by the modulegranteeon the
required number of channels, modulation types, and modes, it should not be
necessaryforthehostinstallertore‐testalltheavailabletransmittermodesor
settings. It is recommended that the host product manufacturer, installing the
modulartransmitter,performsomeinvestigativemeasurementstoconfirmthat
theresultingcompositesystemdoesnotexceedthespurious emissionslimitsor
band edge limits (e.g., where a different antenna may be causing additional
emissions).
B. Thetestingshouldcheckforemissionsthatmayoccurduetotheintermixingof
emissions with the other transmitters, digital circuitry, or due to physical
properties of the host product (enclosure). This investigation is especially
important when integrating multiple modular transmitters where the
certificationisbasedontestingeachoftheminastand‐aloneconfiguration.Itis
important to note that host product manufacturers should not assume that
because the modular transmitter is certified that they do not have any
responsibilityforfinalproductcompliance.
C. If the investigation indicates a compliance concern the host product
manufacturerisobligated to mitigate the issue.Hostproductsusing a modular
transmitteraresubjecttoalltheapplicableindividualtechnicalrulesaswellas
tothegeneralconditionsofoperationinSections15.5,15.15,and15.29tonot
cause interference. The operator of the host product will be obligated to stop
operatingthedeviceuntilthe interferencehasbeencorrected.