Instruction manual

7
Care and cleaning
Always disconnect the appliance from the power before any cleaning or maintenance.
• The refrigerator and freezer sections should be cleaned using a solution of bicarbonate of soda and lukewarm water.
• Do not use abrasive products or detergents. After washing, rinse and dry thoroughly.
• Clean the shelves and balconies separately by hand using soap and water. Do not put them in the dishwasher.
• The evaporating tray and water drain hole (at the back of the refrigerator compartment) should be cleaned periodically to
prevent the defrosted water from collecting inside the refrigerator compartment. The drainplug can be used to clear the
drain hole.
• Once cleaning is complete, then reconnect the power.
• If the appliance is not used for prolonged periods of time, unplug and clean the appliance. The doors should be left
slightly open to prevent the formation of mildew and smell.
Changing the light bulb
Disconnect the appliance from the power.
• Remove the light cover by pressing on the hooks on both sides of the cover.
• Unscrew the light bulb to remove it and replace with a new bulb (not more than 15W).
• Replace the light cover and reconnect the power.
This appliance must never be installed close to heat sources, e.g. heating elements, cookers or in damp places.
• The plug should be fully accessible at all times.
• To ensure the appliance is level, you should use the height adjustable feet at the front of the appliance.
• The cooling system at the rear of the appliance must not touch the rear wall.
• The appliance must be installed with adequate ventilation. Ensure that there is 15 cm clearance above the appliance, and that
there is space between the rear of the appliance and the wall.