WC430 Integrated Slimline Dishwasher Manual for Installation, Use and Maintenance Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.
rtant Important The CDA be Group cannot be responsible injuries losses caused incorrect of usethis or installation of this Group Ltd cannot heldLtd responsible forheld injuries or lossesforcaused byor incorrect use or by installation Please note CDA reserve the right to invalidate thewith guarantee supplied with thisincorrect product following incorrect Please noteproduct. that CDA reserve thethat right to invalidate the guarantee supplied this product following installation or misuse of the appliance.
• The plastic housing on the water inlet pipe contains an electrically operated valve. The wires that connect to this valve are inside the inlet hose. Do not cut through the inlet hose, and do not put the plastic housing in water. • Children could get locked inside the appliance. Therefore when disposing of an old appliance, cut off the plug and set aside, and damage the door lock so that the door can no longer be closed.
Starting a Programme • Turn on the water tap • Press the Power button. • Press the Programme Selection button until the required programme light is illuminated. When you close the door, the dishwasher will beep once and the programme will start automatically. The Delay Timer This dishwasher is equipped with a variable delay timer which can be set for 2, 4, 6, 8, 10 or 12 hours’ duration. • To set the delay timer, first switch the dishwasher on by pressing the power button.
Detergent To fill the detergent dispenser 1. Push the latch to open the dispenser. 2. Add the required amount of detergent to the main detergent dispenser. If your dishes are in need of an intensive wash, then add 5 cm3 of detergent into the prewash section of the dispenser. 3. Then close the detergent dispenser lid until the latch locks. Please note: You should only use detergents designed specifically for use in dishwashers. Combination detergents (e.g.
Softener Adjustment The efficiency of your dishwasher depends on the softness of the tap water. To ensure best efficiency, the dishwasher is equipped with a system that reduces the hardness in the mains water supply. The efficiency will increase when the system is correctly set. To find out the water harness level of your water supply contact your local water board.
nse Aid RinseRinse Aid Aid fill the rinse aid compartment Rinse Aid To fill theTorinse aidrinse compartment fill the aidcompartment compartment To fill the rinse aid Open the rinse aid compartment by turning and removing the cap as 1. Open the rinse aid compartment by turning and removing the cap 1. Open the rinse aid compartment by turning and removing the as cap as shown in figure 4. 1. Open the rinse aid compartment by turning and removing the cap as shown inshown figurein4.figure5. in figure 4.
General Information To adjust the heightBaskets of the upper basket: Dishwasher Dishwasher Baskets • Open the basket as shown in figure 8, by turning them to To adjust the height ofretaining the upperclips, basket: the side. To the upper basket: 1. adjust Open the height basket of retaining clips, as shown in figure 7, but turning them to • Remove the upper basket, and relocate alternate setturning of wheels onto the the side. 1.
Technical Information 8 Width 44.6 cm Depth 55 cm Height 82 cm Capacity 9 standard place settings Mains water pressure 0.03-0.
Programme Listing Programme names and temperatures Intensive 70O wash Normal 55O wash Economic 50O wash Glass 45O wash Rapid wash 40O wash Prewash No heat Level of soil High Medium Medium Small Small NA Detergent amount A=Main B=Prewash A+B A+B A+B A A NA Hot prewash Cold prewash Cold prewash 70O wash 55O wash 50O wash 45O wash 40O wash Cold rinse Cold rinse Cold rinse Warm rinse Cold rinse Hot rinse Hot rinse Hot rinse Hot rinse Dry Dry Dry Dry End End End End
Care and Maintenance Before beginning any care or maintenance, you should always disconnect the appliance from the electricity supply, and also turn off the water supply. Door seals Wipe the dishwasher door seals regularly with a damp cloth to remove any residue. Filters You should clean the filters at least once a month.
Failure Failure Codes and Codes Troubleshooting and Troubleshooting Your dishwasher Yourcontrol dishwasher panelcontrol is equipped panelwith is equipped a diagnostic withdisplay a diagnostic to help display in thetoevent helpof in athe problem event of with a problem the appliance. with the appliance. Failure Codes and Troubleshooting The programme indicators also serve as a diagnostic display to help in the event of a problem with the appliance.
Failure Code and Troubleshooting Problem The programme will not start Water remains inside the dishwasher at the end of the programme 12 Possible cause Check the plug, fuse and circuit breakers of the mains supply The water tap is turned off The dishwasher door is not fully closed The water inlet filter or the machine filters are blocked The water drain hose is blocked or kinked.
Electrical information Warning! This appliance must be earthed. The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. To change a fuse in this type of plug, follow the steps below: 1. Remove the fuse cover and fuse. 2. Fit replacement 13A fuse, ASTA approved to BS 1362 type, into the fuse cover. 3. Replace fuse cover. Important: Do not use the appliance without the fuse cover in position.
Installation • Do not install this appliance if it is damaged in any way. Installing a damaged appliance may invalidate the warranty. • The water supply tap should be located in an adjacent cupboard so that it can be accessed after installation. • Ensure the appliance is level by adjusting the feet as necessary. • Only use the water inlet supplied with the appliance. • If the water pressure is above 10 bar, a pressure relief valve should be used.
To contact our Customer Care Department, or for Service, please contact us on the details below. Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.