POWERmow 24V Cordless Cylinder Mower User Manual Innovation from CY1 C Enterprise Ltd
THANK YOU Thank you for investing in a CEL product. The 24V Cordless Cylinder Mower has been engineered and made to demanding high quality standards; ease of operations and safety have taken a major role in development. Proper care of your product will give you years of trouble-free use. Normal wear and tear, including accessory wear, is not covered under guarantee.
Contents 1.0 2.0 3.0 4.0 5.0 5.1 Important Safety Notes Unpacking Assembly Safety Key Battery Charging 6.0 7.0 8.0 9.0 9.1 10.0 10.1 Cutting Height Battery Level Warning Blade Adjustment Mowing Tips Emptying Grass Collector Starting & Stopping Over Work Protection 11.0 11.1 11.2 12.0 13.
Important Safety Notes 1.0 READ ALL INSTRUCTIONS BEFORE USE. RETAIN INSTRUCTIONS FOR FUTURE REFERENCE. THIS MACHINE CAN CAUSE SERIOUS INJURIES. WARNING: When using an electrical appliance, basic safety precautions should be observed, including the following, to reduce the risk of fire, electrical shock or injury: 1. Read the instructions carefully. Be familiar with the controls and the proper use of the appliance. 2. Do not use it as a toy. 3.
Important Safety Notes 1.0 20. Stop the blade if the appliance has to be tilted for transportation when crossing surfaces other than grass, and when transporting the appliance to and from the area to be mowed. 21. Never operate the appliance with defective guards, or without safety devices, for example deflectors and/or grass catchers in place. 22. Switch on the motor according to instructions and with feet well away from the blade. 23. Do not tilt appliance when switching on the appliance. 24.
Unpacking 2.0 3 4 5 8 9 6 7 11 10 1 2 figure1 1. Main Unit 2. Battery Pack 3. Lower Frame 4. Middle Frame x2 5. Upper Frame 6. Nut & Bolts x6 7. Cable Clips x3 8. Charging Adaptor 9. Keys x2 10. Grass Collector 11.
Assembly Unpacking 1. Unpack and remove the whole unit from its packaging, and ensure all the parts are present. (See figure1) Caution: Remove the Safety Key and Battery from the mower to safely work on the product. 2. Fit the Lower Frame onto the two large lugs on the Main Unit. Fit one side and then flex the other side of the frame until it fits over the opposite lug. 3. To assemble the Upper Frame to the 2 Middle Frame parts.
Assembly 5. Use 4 nuts and 4 bolts to hold the upper and middle sections in place on the Lower Frame. Insert the bolts from the outside and fit the nuts on the inside of the frame. 6. Once the frame is assembled, connect the plug on the handle cable to the socket on the main unit. Tighten the screw ring to secure the cable. 7. Secure the cable to the handle using the 3 cable clips, leave some slack on the cable to allow free movement. 8.
Safety Key IMPORTANT : There is a safety key fitted to this device, the product will not work without it. . The key needs to be fitted and turned to the on position for the product to operate. Always remove the key and battery before carrying out any adjustments or maintenance on the mower, or if the mower is left unattended. Before first use charge the battery for 16 hours. Please refer to the section on charging and recharging. 4.
Battery If the battery is damaged in any way do not attempt to charge it and replace immediately. Remove the battery from the product by rotating and lifting with the handle Keep clear of any moisture, direct sunlight or temperature extremes. Fully unwind the charger cable, plug into a suitable mains outlet, the light on the charger will turn green. Fit the plug securely into the socket on the battery. The light will turn red while the battery is charging and back to green once the battery is fully charged.
Charging 5.1 Remove the Battery before charging. Do not attempt to charge the battery while in the mower. Never store the mower with a flat Battery. The battery should ideally be stored between 10º C and 24º C (50º F and 75º F). The battery will not be damaged if it is charged for longer than 16 hours, but it is advisable not to leave it on for more than 48 hours, as this might shorten the battery life. POWERmow can be used as a push mower if the battery needs charging.
Cutting Height 6.0 Caution: For safety ensure that the Safety Key and Battery are removed from the Mower before adjusting the height. To ensure that the roller is aligned correctly, it is recommended that the height is adjusted on a level surface. It is also recommended that the Grass Collector be removed as this will allow easier access to the Locking Knobs. Raise Locking Knob Pull out 1. Pull out the knobs on both sides of the roller. 2.
Blade Adjustment 8.0 SHARP BLADES-BE VERY CAREFUL. Caution: for safety ensure that the Safety Key and Battery are removed from the Mower before adjusting the blade. To adjust the blade turn the 2 bolts on the blade shield. The cylinder should almost touch the blade, but do not over tighten it. If the cylinder hits the blade it is too tight and will damage the cutting edge; loosen the nuts.
Mowing Tips 9.0 Before mowing ensure the area to be cut is clear of stones or other objects, which may damage the mower or cause injury. Start by mowing around the edges of your lawn, then cut the centre area in stripes. Mow twice a week during growing season, the grass will be weakened if more than a third of the length is cut away at one time. The mower should be parked, the operation lever released and the blades allowed to stop before the grass collector is removed for emptying.
Starting & Stopping 10.0 The handle is designed with a safety button to prevent accidental starting. 1. Press and hold the safety button ‘A’ located on the left of the upper handle, then squeeze the operation lever ‘B’ towards the upper handle. 2. Release the operation lever ‘B’ to stop the mower. IMPORTANT : when releasing the operation lever, wait for the blades to stop turning before clearing any grass or putting your hands near the blades! Over Work Protection B A B 10.
Care and Maintenance 11.0 CAUTION : Remove the key and Battery before carrying out any maintenance. Do not accidentally turn the unit on while cleaning it. Check for any faults such as loose or damaged blades, loose fittings and worn or damaged components. Ensure the mower is in full working order before operating it. Check that covers and guards are correctly fitted and are not damaged in any way. Carry out any repairs before using the lawnmower again. Clean the lawnmower using a soft brush or cloth.
Storage (continued) 11.1 For storage in confined spaces the handles can be removed from the mower. Disconnect the power cord and flex the lower handles to remove from the frame locating lugs. Never Store the Mower With a Flat Battery. The battery should ideally be stored between 10ºC and 24ºC (50ºF and 75ºF). To keep the battery in prime condition it is best to charge the battery after each use, and every 3 months if stored. After each use charge for 16 hours to ensure the battery is fully charged..
12.0 FAQ Why does my mower stop? CAUTION : Remove the key and battery before carrying out any maintenance. Remove any build-up of grass or debris from the blade area. Check the blade for damage and oil if necessary. Make sure the battery is charged, properly seated and locked in position. (see Section 4.0) Ensure the key is fitted and in the ON position. (see Section 3.0) The overload electronics is preventing damage, allow a few minutes for the mower to cool clear any debris and resume) (see Section 8.
13.0 Technical specifications Unit operating cycle with full battery Cutting width Cutting height Battery operating voltage Charging period for fully discharged battery Motor output power Battery charger output Sound Power Level, LPA,d Sound Pressure Level, LWA,d Vibration Weight - 25 to 90 minutes* 40 cm 15, 25, 35, 45 mm 24V DC 16 hours 54 W 28.6V DC 800mA 70 dB(A) 94 dB(A) 1,0 m/s 2 18.
C Enterprise Ltd C Enterprise Limited UK • HK • www.cel-global.com info@cel-global.
