Instruction manual

6
ALTITUDE UNITS and
AUTO POWER OFF
BACKLIGHT AUTO
OFF and ALTITUDE
BENCH-POINT
DATA LOG PERIOD
and BAROMETER
RECORD TIME
*To return to the Compass page, press the POWER key
quickly once.
a. Time Zone Setting
In order to guarantee an accurate clock reading for your reTrace
™
Deluxe, the clock is based on GMT (Greenwich Mean Time). The
default setting is +8:00, which means most users will need to
adjust the time. This is a very simple undertaking. Follow these
steps:
1. Refer to the GMT Zone map below, find your zone and
its + or – setting.
2. Make sure time is highlighted red in the settings window.
3. Press your SET key. This will bring up a full window with the
clock setting of +8:00.
4. Press SCROLL or CHANGE SETTINGS to toggle through
the GMT settings until you find your setting number.
5. Press the SET key to make your selection. This will return you
to the setting window.
NOTE: GMT does not account for Daylight Savings. If you
are in the US and it is summer, add 1 hour to your setting.
For example, if you are located on the west coast, your GMT
setting would be -8:00. To account for daylight savings, add
1:00 to show the correct setting of -7:00.
GMT Zones Map
-12 -11 -10 -9 -8 -7 -6 -5 -4 -3 -2 -1 +1 +2
GMT
+3 +4 +5 +6 +7 +8 +9 +10 +11+12
b. Temperature Unit Setting
You can choose the temperature unit of measure here. The default
setting for the temperature unit is °F. Changing Unit Setting is
easy. With the Temperature Unit Setting window highlighted,
press your SET key once. °C should now be displayed. To go
back to °F, press your SET key again.
c. Time Format Setting
The default time format of the device is set to 12H. To change to
24H, press your SET key once. To go back to 12H, press your
SET key again.
d. Distance Unit Setting
You can set your distance unit settings between Metric and
Imperial Standards. The default Distance Unit is set to Yd (Yards).
To Change to M (Meters), press your SET key once. To go back
to Yd, press your SET key again. *Note: Your choices are Yd or M
only, but the reTrace
™
Deluxe will adjust the units based on your
distance from the POI and display them accordingly. For instance,