Instruction manual

7
if the unit of measure is set to M and you travel past 1000 meters,
the unit will automatically switch to Km (Kilometers). It will do the
same with feet and miles.
e. Altitude Unit Setting
The default Altitude Unit is set to Ft (Feet). To Change to M
(Meters), press your SET key once. To go back to Ft, press your
SET key again.
f. Auto Off
The default Auto Off time is set for 5 Minutes. You can set your
reTrace
™
Deluxe to turn off at 5, 10, 30 or 60 minutes as well
as stay always “on”. Press your SET key to toggle through the
choices.
g. Backlight On Setting
The default value for Backlight is “on”. You can adjust the timer to
5, 10, 15 and 30 minutes. Press your SET key to toggle through
the choices.
h. Altitude Benchmark Setting
In order for your altitude reading to be accurate, you need to set
the benchmark height. reTrace
™
Deluxe offers two ways to do this.
To pull up the choice window, press the SET key.
1. Set altitude using GPS: On the top of the screen is a satellite
icon with a number. This is the GPS altitude. This is a fairly
accurate reading of your height based on the GPS coordinates
and the air pressure reading from the unit. To select this
benchmark setting method, press the SET key.
2. Manually set altitude: To manually set the altitude benchmark,
press the CHANGE SETTING key once to highlight the
Manual setting (finger) icon. Press the POWER key to open
the manual setting window. Using your SCROLL key or the
CHANGE SETTINGS keys, enter the height you would like for
your benchmark.
The most accurate way to set the benchmark is to be at sea
level and enter 0000 for the height. If this is not possible, there
are many online sources for acquiring your altitude benchmark.
Once you acquire your local benchmark, you need to go to that
spot and enter the altitude into your reTrace
™
Deluxe.
i. Data Log Period Setting
The Data Log setting tells the reTrace
™
Deluxe how often to
record data. This is a powerful tool that collects info about your
travels that can be saved and uploaded to the reTrace
™
Deluxe
software for analyzing. The default time for the Data Log Period is
5 seconds. Press your SET key to select and make changes. This
window appears:
Press your SCROLL and CHANGE SETTINGS keys to change
the digits to your desired number as described in previous
instructions. When finished, press the POWER key once to return
to the main screen.
j. Barometer Curve Record setting
To change the interval of barometric recording points, press your
SET key and choose 5, 10, 30 or 60 minutes. The default setting
for recording the barometer curve is 5 minutes.