Use and Care Manual

19
Step One:
Pilot holes must be drilled rst. To do this, use a fence bracket
as a guide and mark the center point for pilot hole locations as
shown in Illustration A. Using a 3/8” drill bit, drill pilot
holes for all Termination Bracket locations.
Step Two:
Measure back approximately 2-1/2” - 4” on the rail as
shown in Illustration B and then bend the rail back as
shown in Illustration C.
Step Three:
Insert the bent piece of rail into the slot on the Termination
Bracket as shown in Illustration D. Make sure the short side
of the bent rail is farthest from the mounting hole in the
bracket. Once the rail is inserted, slide the provided
bent pin into place as shown in the illustration.
Step Four:
Attach the Termination Bracket using the supplied lag screw (A)
and washer (B) as shown in Illustration E. Once the bracket is
attached to the post, tension the rail from the opposite end to
take up slack.
NOTE: Do NOT overtighten the lag screw. Termination
Bracket should t snug to post, but still be able to move
with slight pressure.
A
B
D
E
C
2
1/2
”  4”
Step One:
Remove existing fence bracket if needed and place T-Bracket
over rail as shown in Illustration A. Use the T-Bracket as a
template to mark hole locations. Using a 1/4” drill bit, drill pilot
holes for all T-Bracket locations.
Step Two:
Measure back approximately 2-1/2” - 4” on the rail as shown in
Illustration B and then bend the rail back as shown in
Illustration C.
Step Three:
Insert the bent piece of rail into the slot on the T-Bracket as
shown in Illustration D. If possible, have the short side of the
bent rail between the bracket and the rail. Once the rail is
inserted, slide the provided bent pin into place as shown in the
illustration.
Step Four:
Attach the T-Bracket using the supplied lag screws as shown in
Illustration E. Once the bracket is attached to the post, tension
the rail from the opposite end to take up slack.
NOTE: A horizontal/diagonal brace assembly is required to
prevent end post from moving when tension is applied. Refer to
Step 2 for bracing assembly instructions (page 10).
A
B
D
E
C
2-
1/2
” - 4”
Step One:
Slide rail through loop and bend back 3”- 4” of rail as shown.
Wrap rail around postand slide bent portion of rail into loop.
Step Two:
Install a CenFlex bracket as shown and pull tension on rail
to pull up tight to post.
Step Three:
B C
2-
1/2” - 4”
Option 3: Termination Loop
Option 4: T-Bracket