User's Manual

Page 5For technical questions, please call 1-800-444-3353.SKU 39152
quickly and safely as possible in


fragments.
If in doubt about the safety of your 8.
project, we advise you to have
the work done by a professional
familiar with applicable safety
practices.
9.
surface capable of bearing the
combined weight of the Adapter and
Jack, the car being lifted, the operator
and any tools being used.
The Adapter is not designed to lift or 10.
lower a vehicle. Suspend the vehicle


lifting device designed to raise and
support weight of vehicle.
The warnings and precautions 11.
discussed in this manual cannot
cover all possible conditions and
situations that may occur. It must
be understood by the operator that
common sense and caution are
factors which cannot be built into this
product, but must be supplied by the
operator.
SAVE THESE
INSTRUCTIONS.
FUNCTIONAL DESCRIPTION
Specications
Weight Capacity 880 lb.
Base Tilt
60° Forward
10° Backwards
Saddle Pin Diameter .094”

(SKU 50183 Heavyweight Floor Jack)
INITIAL TOOL SET UP/
ASSEMBLY
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Unpacking
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353 as soon
as possible.
ASSEMBLY
NOTE:1. The Base (38) of
the Transmission Adapter is

Steel Angles (6) need to to be
attached to the Base. Some other
minor assembly steps are required,
as follows.