User's Manual

Page 7For technical questions, please call 1-800-444-3353.SKU 39152
The bottom of the Base Shaft (18) is 7.
then securely placed into the saddle

hold the Transmission Adapter in
place. See Figure 5.
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Inspect tool before use, looking
for damaged, loose, and
missing parts. If any problems
are found, do not use tool until
repaired.
Tool Set Up
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION: Remove load
and lower Transmission Jack
before performing any
inspection, maintenance, or
cleaning procedures.
TO PREVENT SERIOUS
INJURY: Do not adjust or
tamper with any control or
component in a way not
specically explained within
this manual. Improper
adjustment can result in
tool failure or other serious
hazards.
General Operating Instructions
WARNING! Verify that Floor Jack is
compatible with this Transmission
Jack Adapter before operation.
Designate a work area that is clean 1.
and well-lit. The work area must not
allow access by children or pets to

Raise the vehicle at least as high 2.
as the combined height of your
transmission and the lowered height
of the Transmission Jack.
When the vehicle is safely raised on 3.
Jack Stands, set the Transmission
Adapter underneath the vehicle.
Position the Floor Jack with the
Transmission Adapter attached so
that the pairs of Angle Irons will hold
the forward and rear ends of the
transmission.
With the vehicle safely supported on 4.

Adapter underneath the transmission.
Pump the handle and raise the unit

contact with the Adapter. Slide the

four Support Brackets (1) over the

Knob (10) so that the adapter base

transmission. Turning the Knob
clockwise will lower (pull down) the
opposite end of the base. Turning the
Knob counterclockwise will raise it.
Tighten the bolts and screws to 5.
support the transmission with the
Brackets
Place the Chain over the 6.
transmission and snap it to the Hook