User's Manual
Page 8For technical questions, please call 1-800-444-3353.SKU 39152
Bolt (22). Turn the nut to retract the
bolt and hold the transmission snugly.
Follow the steps in your vehicle’s 7.
drive shaft and any and all mounting
bolts and/or nuts.
Depending on type of transmission, 8.
you may need to move Jack and
transmission back a few inches to
free input shaft of the transmission.
Prior to moving the transmission, 9.
double-check that it is secured to the
Transmission Adapter.
WARNING! 10. Transmission is heavy
and prone to rocking during lowering
procedure. Use caution when
lowering it to prevent accidental
rocking of it.
TRANSMISSION
INSTALLATION
Verify that the vehicle is properly and 1.
safely raised on the Jack Stands.
WARNING!2. Do not work under a car
individually rated less than the total
weight of the vehicle.
Verify that you have all of the 3.
necessary hardware and supplies
to install the transmission. Do not
leave the transmission suspended by
the Floor Jack if you need to obtain
additional supplies.
Check to make sure the Chain is 4.
tightly holding the transmission.
Roll the Floor Jack under the vehicle. 5.
Place it so that the transmission
centerline is as close to the centerline
of the engine as possible.
Begin raising the transmission. 6.
Continue raising it until it is at the
installation height.
With the transmission at the correct 7.
height in the transmission tunnel of
transmission if needed.
WARNING!8.
the position of the transmission
methods described.
If you are working and load becomes 9.
SUFFERED! In this event, clear area
as quickly and safely as possible in
FAMILIAR WITH
APPLICABLE SAFE PRACTICES.
Remove Chain from around 10.
transmission. Install transmission into
the vehicle.