Installation guide

This guide is designed specifically for installers who are familiar with the
installation of standard sliding gate motors, but do not know the specifics
of the D2 Turbo Low-Voltage.
Please do not proceed with the installation until you have
read and fully understand the Safety instructions included in
your product packaging. The Safety instructions are also
available on www.CentSys.com, and may also be
obtained by contacting Centurion Systems on [phone]
887 (SA only).
This icon denotes variations and other aspects that should be
considered during installation.
This icon indicates tips and other information that could be useful
during the installation.
This icon indicates a warning, caution or attention!
Please take special note of critical aspects that MUST be
adhered to in order to prevent injury.
3
9
Which bit is what?
1. Motor fuse
2. Motor enclosure unit
3. Camlock cover
4. Release thumbwheel
5. Foundation plate
6. D2 Turbo Low-Voltage
controller
1
7. 12V 7Ah or 5Ah battery
8. Battery strap
9. Pulley guard
10. Gate mounted origin marker
11. Origin marker bracket
2
5
7
6
10
11
4
8
1. Introduction
2. Important safety instructions
3. Icons used in this guide
The D2 Turbo Low-Voltage is a cost-effective domestic sliding gate
operator for gates weighing up to 250kg. Its logic controller and onboard
charger require only a low-voltage AC or DC input, which means that
there is no need for high-voltage cable runs and consequently a reduced
risk of electric shock.
It is a 12V DC battery operated unit with the following limitations:
Gate mass maximum: 250kg
Starting pull force: < 18kgf
Rated running force: < 9kgf
Maximum speed: 24 metres/minute
Maximum gate length: Ten metres
Design life: Ten years at ten cycles per day
5. Technical specifications
4. General description
6. D2 Turbo Low-Voltage identification